Power Saver by BMASS to improve lighting efficiency
BMASS energy saving system, Power Saver, is a micro-processor controlled
unit that manages and reduces lighting power, and improves lighting efficiency. It has
the unique capability to offer significant cost savings in the operation of fluorescent
lighting power (up to 30%), whilst achieving a major reduction in greenhouse gas emissions
and pollution of the environment.
Power Saver will enable existing buildings and tenancies become more energy efficient
without the need for expensive and potentially non cost effective lighting upgrades.
Power Saver installed in T8/T12 fluorescent lighting circuits, with very reliable high
performance magnetic ballasts (including older discontinued EEI C/D Class models), will:
- save far more energy than comparable T8 fluorescent lighting circuits fitted with electronic ballasts;
- save as much, if not more, energy as T5 fluorescent fittings at a much lower installed and whole-of-life cost;
- allow complementary energy saving and lighting efficiency measures to be implemented.
The base technology utilised in BMASS Power Saver may often be referred to in literature as a type of:
- reduction voltage system;
- autotransformer;
- lighting power / control system.
BMASS offer two standard products to suit customer's requirements:
- Single Phase 10 kVA Unit - to cover the installation of up to 210 (36W) fluorescent tubes for each BMASS Power Saver unit; and
- Single Phase 5 kVA Unit - to cover the installation of up to 105 (36W) fluorescent tubes for each BMASS Power Saver unit.
In each case BMASS Power Saver units are integrated directly into existing lighting power
circuits, at or near the switchboard. A significant and unique feature of Power Saver is its
ability to manage multiple lighting circuits unlike other products that only operate on a single
lighting circuit. Importantly, Power Saver is not a lighting dimming device.
The unit is considered an 'appliance' and does not normally require any special approval prior
to installation.
Three phase units (>600 (36W) tubes) and 2.5kVA units (around 50 (36W) tubes) are available on
request, but are built to order to suit specific installation requirements.
For further information contact:
Bmass Energy Saving Solutions Pty Ltd
phone: 07 3206 9668
web: www.bmass.com.au
| 
