NEWS ARTICLE ARCHIVES



Stain Repellent Coating for Pavers Sydney from Durotech

paths with durotech wos stain repellent coating

Durotech WOS

This is a non-flammable, water-based and fluoro-chemical solution that provides an invisible barrier which repels water, oils and other stains. It is extremely easy to apply and provides an almost instant stain repellence to paths, walls, concrete floors, cement based pavers and tiles, mortar and grouted joints, stone, limestone, terracotta and other brick products.

Additionally, treated surfaces such as stone, terracotta and concrete shows this product inhibits the growth of fungus and algae.

Principal Characteristics

- Inhibits the growth of fungus and algae
- Provides a barrier which repels both water and oils
- Water based, low viscosity
- Allow easy removal of stains
- Easy to apply & quick drying
- Colorless which cures to an invisible coating
- Particularly good performance with concrete and pavers
- Chemically bonds to the substrate and provides a durable protection

Surface Preparation
Surfaces must be free from dust, dirt, oil and contaminates, loose particles, curing compounds and flaking concrete etc. Dirty surfaces should be thoroughly cleaned with high pressure water and/or detergent.

Application
Apply DUROTECH WOS by brush, roller or mop. If sprayed read Health & Safety directions before use. To obtain an even coverage on terracotta, dampen the surface with a little water before applying the product. Apply at the rate of 0.5-1.0 Litres/m² [1-2m²/Litre] depending on porosity.

Cleanup
Durotech WOS may be cleaned from equipment with water whilst still wet.

Precautions
Always do a test patch in an inconspicuous area prior to application.

Health & Safety
Refer to Durotech MSDS prior to use. Durotech WOS used to be known as Duroshield and Duroseal PSM-1.
1. When spraying, use a respirator that meets Australian Standard AS-1715 requirements, to reduce breathing in the product, DO NOT SPRAY A FINE MIST, use a coarse spray pattern. To avoid creating a fine mist, maintain spray pressure below 60psi (400kPa) and use a coarse spray nozzle tip.
2. Work close to the surface to be coated.

Limitations
DUROTECH WOS is effective on porous surfaces only and is not suitable for use in situations of hydrostatic pressure. DUROTECH WOS is not suitable as a pre- treatment for painting.

DUROTECH WOS will not seal movement and/or hairline cracks.

General Information
Colour: Dries Clear
Weather Resistance: Excellent
Dry Time: 2 hours
Recoat: After first coat sinks in
Coverage: Depends on the porosity. 0.5-1 Litres / m² [1-2 m²/Litre]
Shelf Life: 12 months unopened at 20°c

Project News Add your Business

Home | About/Services | News Lounge | News Archive | Product Archive | Tender News | Testimonials | Conditions of Use | Privacy Policy

Company Listings:   A B C D E F G H I J K L M N O P Q R S T U V W X Y Z

facebook Twitter Instagram YouTube

© 2022 SPEC-NET