Water Based Concrete Sealer from Know How Concrete Technologies

DeepSeal Natural 'W'

(Water Based)

REQUIREMENT: To seal untreated concrete, paving and masonry products with the view to providing long term protection from staining, without affecting natural texture or appearance.

HOW TO SPECIFY: All exposed surfaces shall be treated by 2 coats of DeepSeal Natural 'W'. The application rate is determined by consultation with a representative of Know How Concrete Technologies. Most surfaces 1 Litre = 4 - 7 m2 per coat. All surfaces to be clean and dry and free of loose materials.

HOW TO USE PRODUCT: Apply two light even coats of DeepSeal Natural 'W' to surface with a brush, roller, lambs wool applicator or low pressure spray. Allow drying between coats (approximately 20 - 30 minutes depending on ambient temperature).

EFFECTS: Reduction in water uptake, water-vapour permeability, concrete corrosion; Resistance to alkalis and carbons; UV Resistance; Surface left unchanged; Lower maintenance efforts and costs.

WHERE RECOMMENDED: All natural unpainted masonry, concrete and pressed clay surfaces.

CLEAN UP: All tools and equipment should be cleaned thoroughly with clean soapy water.

CAUTION: Any excess material should be mopped from surface and not allowed to pond and dry.

SERVICE LIFE: DeepSeal Natural 'W' should give many years of protection; however life expectancy will depend on the surface and environment in which it is placed.

HANDLING PROCEDURES: DeepSeal Natural 'W' is not classified as hazardous, but normal hygiene should be observed following use. It is recommended that protective equipment be worn during use. Avoid contact with eyes and do not consume. Should contact occur, flush thoroughly with clean water.