Installing InnvoLoc is fast and simple from Innvotech

InnvoLoc can be installed in approximately 50% of the time taken to install a standard tile floor. In addition, 1-2 days of elapsed time are eliminated as there is no need to wait for tile adhesives to dry. The process for installing InnvoLoc is quite straightforward and is shown below.

Installing InnvoLoc where less than a full tile required is easy. Just cut the InnvoLoc'd tile with a wet or dry tile saw or angle grinder to the size required. The InnvoLoc base will not detach from the tile during the cutting process.

Installing the last tile or row against a wall is also easy. Leave a 5mm expansion gap from walls and gently pull the last tile or row into place. If necessary use a floating flooring rubber-coated pry bar to assist pulling the tiles into place. Remove the teeth on the InnvoLoc bases that are installed against walls.

InnvoLoc is compatible with a wide range of standard floating floor trims and edge profiles which are readily available in a variety of colours, materials and designs. Note, it is more preferable to use floating floor trims than standard tile trims as InnvoLoc is a floating floor system.