Slate Stack Stone Wall Cladding from StoneClip

This is a project of cladding a wall at the Gold Coast with slate Stack stone which is going to be installed to over 4000mm high in places.

The installer Mr Finn Pedersen (0438 590 985) of Pedersen Group contacted me about the project and I convinced him to purchase the Slimline Supportclip special of 1 x cutter machine + 200 of the Slimline Supportclips.

He purchased a further 250 clips, making a total of 450 to be used on his project. The project is around 100m2 and Finn is installing the clips on every 3nd row and the installation is as quick as the labourer can precut and install the clips into the panels with a quick setting epoxy.

By doing this it is allowing him to go to the full height where he needs to without worry of the panels falling off below him as they keep going higher.

This is the main worry when installing these cheaper stone panels - the installer doesn't know when the glue below has fully set and in that doubtful time period is when disasters occur.