FRP Spray Adhesive Spray-Lock from Allplastics

Spray-Lock® FRP Spray Adhesive

PRODUCT CHARACTERISTICS

Spray-Lock® FRP Spray Adhesive bonds approved wall material for commercial and residential applications. Material must be structurally sound for use in commercial or residential applications.

Spray-Lock® FRP uses 60% less adhesive than traditional trowel-on adhesives.

Spray-Lock® FRP increases productivity with a faster application rate, saving you time and money. Spray-Lock® FRP comes in easy to use aerosol cans.

ADVANTAGES

• Saves Time
• 4 hour Working Time
• Apply Direct to Wall
• Instant Grab
• No Offensive Odors
• Water-Based
• No Troweling
• Non-Flammable

SUITABLE SUBSTRATES

Spray-Lock® FRP Adhesive adheres approved wall coverings and materials onto the following properly prepared smooth substrates:

- Plasterboard, cement sheet, Scyon sheet, timber, MDF, ceramic tiles, metal, FRP (Fibre Reinforced Plastic), concrete, glass, etc.

SUITABLE MATERIALS FOR APPLICATION

- Acrylic sheet & mirror, polycarbonate sheet & mirror, PETG, MDF, timber, metal, Alucobond, rigid or foam styrene, rigid or foam PVC, Rowlux illusion film, Korogard high impact wall protection, etc.

*As substrates and materials vary greatly, compatibility and suitability of substrate and material to be confirmed by customer prior to any production

NOTE: Joint compound may need to be primed if it continues to dust.

TECHNICAL CHARACTERISTICS

Spray-Lock® FRP's formula is a water based acrylic blend spray adhesive that has milky white frost bubbles in appearance and provides immediate shear strength during installation.

Spray-Lock® FRP adhesive is solvent free, emits no harmful fumes and contains <0.0g/ml VOC (Volatile Organic Compounds) content. According to EPA Method 8260B.

Spray-Lock® FRP uses a safe non ozone depleting HFC propellent.

*Green Seal Certified: This product meets the Green Seal™ Standard for Adhesives for Commercial Use, GS-36, based on its reduced hazard to humans, reduced volatile organic compounds, and reduced hazardous ingredients. **According to EPA document: "National Volatile Organic Compound Emission Standards For Consumer Products" for aerosol adhesives.

TECHNICAL DATA

Chemical Type: Water-based Acrylic Blend Appearance: Milky white frost bubbles Odour: Sweet mild odour Flash point: Will not burn NFPA 704 Flammability Rating: 0 (Non Flammable) Storage: Do not subject to freezing temperatures. Shelf life: 3 years if unopened Open time: 4 hours Dry time: Once adhesive is dry to touch (10-20 minutes) VOC content: <0.0g/ml per EPA Method 8260B

STANDARD AEROSOL

Shake aerosol can well. Snap blue tab on top of trigger to activate the can, aim at desired substrate. Pull blue lever to spray adhesive.

COVERAGE GUIDE - STANDARD AEROSOL 70 ft2 (6.5 m2) 2 - 8ft X 4ft Sheets

Coverage rates are a guide and figures will increase or decrease depending on the spraying technique implemented Please refer to Installation Guidelines for detailed instructions.