Thermaloc Hot and Cold Pipe Supports from Sekisui Foam Australia

Thermaloc™ Thermobreak® Hot and Cold Pipe Supports

QUALITY FEATURES:

• Thermaloc profile ensures an airtight finish
• Thermaloc decreases installation time as it locks easliy together
• Closed cell so that it will not absorb moisture or degrade with time
• Made from high density polyolefin foam
• Will not erode with pipe movement
• Fire rated to AS1530.3
• Smoke density and toxicity to BS6853
• Made from recycled material and is recyclable

Thermaloc is light weight and extremely tough. Just place the two pieces over the pipe, squeeze together gently, and apply AS1530.3 approved foil tape ensuring complete coverage.

Advantages to the end users:

Built in Loc

Once tightly taped, Thermaloc will prevent any air movement through the join. This is especially important in cold line applications to prevent potential air condensation.

Tough and Durable

Thermaloc pipe supports are made of high density, crosslinked, closed cell polyethylene foam. As they are closed cell they absorb negligible moisture, and retain their insulation properties throughout the life of the installation.

Non Erosion with Pipe Movement

Pipes move with contraction and expansion, eroding the ferrule. The tough PE foam will resist movement and prevent gap formation over time.

Health and Safety

As the blocks are preformed there is no need for cutting, so there is no dust and no mess. They do not emit fibrous particles during installation or over time.

Performance Life

Thermaloc is closed cell and unaffected by water and humidity. This ensures continual performance over the life of the installation.

Chemical Resistance

Thermaloc is resistant to detergents, diluted acids, alkalis, alcohols, esters and fungi ensuring performance in even the most demanding applications.

Compliance with BCA Fire Hazard Properties

Thermaloc complies with the Building Code of Australia (BCA) specification C1.10 Fire hazard properties for materials used in Class 2 - 9 buildings*.

• Spread of Flame Index: 0
• Ignition Index: 0
• Heat Evolved Index: 0
• Smoke Developed Index: 0-1(* foil faced)

Quick, Easy and Safe Application

No more cutting. This ensures a flat surface to butt insulation against, allowing a tight and secure joint. No fibers, no dust, no mess to clean up afterwards. No special face masks or gloves required.

Wall Thickness Available

20 mm, 25 mm, 38 mm, 50 mm walls and made to order wall thickness and ID.

Length Along Pipe

The standard 'on pipe' length is 50 mm. 75 mm is available on request.

Contact Sekisui Foam Australia or your local agent for more information.